• General 10.08.2017 Comments Off on Stages Of Parquet Works

    1. Preparation The substrate must be dry – the percentage of moisture content of no more than 2% of the firm hard, without peeling, level – elevation of 2 meters length should not exceed 2mm. To improve the adhesion (bond) surface foundation soil. In order to protect flooring from moisture (hitting from the floor) screed is impregnated with a special composition (moisture in the interaction with this compound crystallizes), thus your hardwood floor protected from moisture. 2.

    Laying plywood to lay a parquet floor needs to be prepared using water-resistant plywood. Plywood 10 mm used in the case when laid parquet is not thicker than 16 mm. Plywood at thickness is not recommended. Plywood must be waterproof. Plywood 12 mm used in the case when laid parquet thickness of 15 – 16 mm. Use of this plywood is not a requirement and only used to raise the floor level. Plywood must be waterproof.

    Plywood 15 mm is used in cases where further laid parquet thickness 20 – 22mm or parquet large size (solid wood). Plywood must be waterproof. Thinner plywood is not recommended. Plywood attached to the base with glue and screws. Bituminous mastic – glue domestic production based on bitumen. The cheapest option for laying the plywood. Mainly used for packing plywood base on which there are remnants of bitumen (after removing the old flooring laid on the asphalt). Mastic acts as a glue and waterproofing. Adhesive properties are based on the principle of suction. Glue sticks to his plywood.

Categories

© 2010-2018 One Million Red Ribbons All Rights Reserved