Decided to start trimming (slopes)? The warranty on the product itself and the hardware is retained. However, be prepared for the fact that, in the case of formation of any defects, the firm will argue that the culprit finish, you and made themselves responsible for the organization which does not carry. Multiplies the value depending on the set of functions. The cost depends on the quality of the profile window, features, ways of opening the valves, the number of accessories, komplekiuyuschih and much more. Subtract the extra features. Do not succumb to the entreaties of management to establish enhanced profile or additional unneeded hardware. Remember: the salary of these ‘advisers’ consists of the percentage of transactions, so for them the more expensive – the better. even in the noisy din of the area and you cold enough to be a standard two-or three-chamber glass, and the proposed vent valve (designed for ventilation), and give up altogether.
It is not designed for our climate and on admission of cold air covered with icing and fails. Test the solution came wizard to install windows. How to control them and what to look for things to be done on the conscience? 1. Take your time. before you withdraw your window, look prepared for the installation to be defective (when will remove your will too late).
2. Note labeling of the profile (a set of specific inscriptions and figures). If the window is manufactured at the plant have to be marked. If it does, ask the installers that this profile. Often Installers and guileless people uninterested – will tell all. Also: On the thickness of the window joints should not exceed 1 to 2 mm, without chipping, sealing tape on the window between the panes should be continuous whole – otherwise it marriage. 1. During installation, ask your masters how much sealing strip and foam they use and why this is necessary. You may find that you have ordered something extra. 2. Once installed, despite the demands of ‘do not touch window during the day ‘, remove it from the protective film, make sure it opens and closes, inspect for scratches, cracks. Also note: On the screen nor in any case should not hang on the dowels (the weight of the entire design is too large for a single foam and fasteners), to do the corners of the frame is the lower bearing blocks; on the mounting screws should not be too tight, otherwise there will be bending the entire frame; on the outside of the box should not be Pay your balance if you see a defect or lack of paid materials. About all the confusion immediately call the company.
